safety of steel plants corex

Corex Process - Wikipedia

There are drawbacks. For example, at the JSW Steel plant in India it was found that to be viable the Corex process still needed about 15% coke. Furthermore, it has also been found that Corex plants require large amounts of oxygen which can be expensive. Also the export gas can make the process highly inefficient. However, this particular problem can be mitigated by using the export gas in electricity production.

Get PriceEmail contact

COREX® — SMELTING REDUCTION PROCESS

Since coking and sintering plants are not required for the Corex process, substantial cost savings of up to 20% can be achieved in the production of hot metal, of a grade similar to that of the blast furnace. Regarding environmental concerns, Corex plant emissions contain only insignificant amounts of NOx, SO2, dust, phenols, sulfides and, ammonia. Emission values are already far below the ...

Get PriceEmail contact

Steel Plants with COREX Process in Operation: A Quick ...

The COREX plant at Bayi Steel will allow local coal to be used, which are significantly cheaper in Xinjiang area. COREX gas can be used as a fuel gas in the downstream facilities to generate electricity or for the production of direct-reduced iron in a region that has almost no resources of natural gas. Essar Hazira Ltd. India . Essar Hazira Ltd. relocated the two COREX plants (C-2000) from ...

Get PriceEmail contact

Corex Process for Production of Iron – IspatGuru

The attractiveness of the Corex process is due to (i) hot metal quality suitable for steelmaking, (ii) low investment and operational costs due to the elimination of coke ovens and by product plant, (iii) low process related emission rates, (iv) use of a wide variety of iron ores and especially non-coking coals, and (v) generation of a highly valuable export gas which can be used for various ...

Get PriceEmail contact

An ideal concept for economic and environmental friendly ...

• Best application for greenfield plants Alternative 4(with additional Corex gas treatment and DR export gas recycling) • Concept available to add Corex gas as reduction gas to existing DR plant without changing DR plant operation practice • Concept allows to produce DRI to substitute 100% NG for allexisting DR plant technologies

Get PriceEmail contact

HEALTH AND SAFETY ADVICE FOR STEEL ERECTORS

Construction Operatives, Plant Operators, Scaffolders, Wall Floor Tilers, Cavity Wall and Loft Insulation Installers and Steel Erectors with the aim of helping to eliminate and reduce the risk of, accidents, injury and ill-health. The booklets are in an easy to use pocket-size format and will be a good reference point to both existing and new entrants working in the industry and will also ...

Get PriceEmail contact

This report has been prepared for the Department of Energy ...

Figure 32: Steel life cycle (Worldsteel, 2014) .....78 Figure 33: CO 2 reduction potential using bio-PCI (Feliciano-Bruzual, 2014) .....80. INDUSTRIAL DECARBONISATION AND ENERGY EFFICIENCY ROADMAPS TO 2050 – IRON AND STEEL Pathways to Decarbonisation in 2050 Page vii LIST OF TABLES Table 1: Energy-intensive industry total direct and indirect carbon emissions in 2012 (data

Get PriceEmail contact

Corex-Green Technology to produce hot metal - JSW

JSW Steel is the first Indian Company to use the Corex technology to produce hot metal. We went for this technology although it was untested in Indian conditions due to its benefits to the environment. Corex is a smelting-reduction process developed by VAI, for cost-efficient and environmentally friendly production of hot metal from iron ore and low grade coal.

Get PriceEmail contact

PRIVATE SECTOR Introduction - Ministry of Steel

hot rolled coils capacity, integrated steel plant based on Corex Process of oxygen iron making. The production facilities include 1.5 mtpa iron ore Beneficiation unit, 3 mtpa Pellet Plant, two Corex units 0.8 mtpa each, 2 x 130 t convertors, two slab casters and hot strip mill with state of art coil box technology. JVSL has a distinction of being certified to ISO-9001:2000 Quality Management ...

Get PriceEmail contact

Steel plant safety concerns. “Nothing is more important ...

10/10/2018  Hazards in steel plant. 1.Coke oven and bypro d uct plant — Here the main hazards are heat, dust, smoke, moving equipment, chemicals, fire and explosion etc.. 2.Sinter plant — In sinter plant ...

Get PriceEmail contact

SAFETY AND HEALTH worldsteel

A good practice or a good idea that works well in one plant can also be a success in another plant and prevent injuries and save lives. worldsteel’s Safety and Health Committee recognises each year member companies that are actively working to improve safety and health within the steel industry. Since 2008, more than 50 examples of best practice have been recognised and made available to the ...

Get PriceEmail contact

Safety in a Steel Plant – General Aspects – IspatGuru

16/10/2013  The health, safety and protection of employees, equipment and the environment are of serious concern in a steel plant since steel plant is an industry of hazardous nature. The health and safety of employees is crucial since it affects both economic and social factors. It is necessary that steel plant management recognizes the advantages of safe work environments and progressively adopt safety ...

Get PriceEmail contact

Using Syngas to make DRI in the MIDREX Process

productivity, reliability and safety while reducing the environmental impact of our processes. ... addition to the hot metal from the COREX® Plant. Jindal Steel Power Limited (JSPL) has built the first MIDREX® Direct Reduction Plant based on commercially available coal gasification technology in Angul, Odisha, India. The plant will use indigenous coal and iron ore to produce both hot and ...

Get PriceEmail contact

Safety culture and reasons for risk-taking at a large ...

01/03/2015  Due to the types of risky workplaces that steel manufacturing plants constitute, the companies need to assure safe working conditions through systematic and regular safety audits and risk analyses (AFS, 2001, SFS, 1977, The Council of the European Communities, 1989). Safety procedures and regulations need to be followed by the management as well as the workers.

Get PriceEmail contact

Health and safety - Steel Construction

Offsite fabrication of components and rapid on site assembly by skilled personnel make steel an inherently safe construction material. Industry surveys consistently demonstrate that steel is the safest material choice. Whilst concerns for health and safety are as important in the fabrication works and steel mill as they are on site, it is at the erection stage where the most visible aspects of ...

Get PriceEmail contact

JSW Steel Limited Corporate Presentation

- Safety and well being of employees, communities and stakeholders is paramount - FY21 crude steel production guidance of 16mt and saleable steel sales guidance of 15mt - Strong track-record and experience of successfully navigating though multiple cycles and emerging stronger • Sharp re-calibration of discretionary spend for Balance sheet conservation, tap into diverse liquidity pools and ...

Get PriceEmail contact

Correx ® Sheet Standard 8' x 4' (2.4m x 1.2m) - 2mm ...

Correx Health Safety Data Sheet. How to order. Correx Protective Sheeting. Published on Thu 23rd May 2013 by M Macdonald. Introduction. Corrugated plastic protector board / sheets commonly known as Correx, Anitnox, Cordek or Fluted Polypropylene, is a widely distributed product to a variety of industries and used for a range of purposes. Because of this it has made it one of our best selling ...

Get PriceEmail contact

SAFETY AND HEALTH worldsteel

A good practice or a good idea that works well in one plant can also be a success in another plant and prevent injuries and save lives. worldsteel’s Safety and Health Committee recognises each year member companies that are actively working to improve safety and health within the steel industry. Since 2008, more than 50 examples of best practice have been recognised and made available to the ...

Get PriceEmail contact

Safety in a Steel Plant – General Aspects – IspatGuru

16/10/2013  The health, safety and protection of employees, equipment and the environment are of serious concern in a steel plant since steel plant is an industry of hazardous nature. The health and safety of employees is crucial since it affects both economic and social factors. It is necessary that steel plant management recognizes the advantages of safe work environments and progressively adopt safety ...

Get PriceEmail contact

Safety and health in the iron and steel industry

This new code, which reflects the many changes in the industry, its workforce, the roles of the competent authorities, employers, workers and their organizations, and on the development of new ILO instruments on occupational safety and health, focuses on the production of iron and steel and basic iron and steel products, such as rolled and coated steel, including from recycled material.

Get PriceEmail contact

Safety culture and reasons for risk-taking at a large ...

01/03/2015  Due to the types of risky workplaces that steel manufacturing plants constitute, the companies need to assure safe working conditions through systematic and regular safety audits and risk analyses (AFS, 2001, SFS, 1977, The Council of the European Communities, 1989). Safety procedures and regulations need to be followed by the management as well as the workers.

Get PriceEmail contact

SAFETY AND HEALTH worldsteel

Steel Safety Day Steel Safety Day is aligned with the International Labour Organisation's (ILO) World Day for Safety and Health at Work. Ahead of the day, scheduled every year on 28 April, worldsteel asks all its members to carry out a special safety audit on the five most common causes of serious safety incidents. Steel Safety Day 2021 . Safety and health Recognition Programme 2020. In 2020 ...

Get PriceEmail contact

Corex Group We produce both spiral and parallel wound ...

Corex is the cores, tubes, consumer packaging and edge protectors division of VPK Group, a rapidly growing integrated industrial group. VPK Group operates in the cardboard packaging sector and has around 6 100 staff spread across 65 plants in 20 European countries. Corex has approximately 1 300 employees. Every year our 30 companies, spread across 16 countries, produce some 300 000 tonnes

Get PriceEmail contact

Health and safety - Steel Construction

Offsite fabrication of components and rapid on site assembly by skilled personnel make steel an inherently safe construction material. Industry surveys consistently demonstrate that steel is the safest material choice. Whilst concerns for health and safety are as important in the fabrication works and steel mill as they are on site, it is at the erection stage where the most visible aspects of ...

Get PriceEmail contact

Correx ® Sheet Standard 8' x 4' (2.4m x 1.2m) - 2mm ...

Correx Health Safety Data Sheet. How to order. Correx Protective Sheeting. Published on Thu 23rd May 2013 by M Macdonald. Introduction. Corrugated plastic protector board / sheets commonly known as Correx, Anitnox, Cordek or Fluted Polypropylene, is a widely distributed product to a variety of industries and used for a range of purposes. Because of this it has made it one of our best selling ...

Get PriceEmail contact

Construction - SteelConstructionfo

The steelwork contractor's health and safety management system addresses the particular hazards and risks in steel construction as well as the normal range of issues in working on construction sites. His planning for health and safety is systemic to all the preparation for erection through risk assessment, devising safe systems of work and working up the erection method statement .

Get PriceEmail contact

Fire safety: Approved Document B - GOV.UK

07/12/2010  Added: 'Approved Document B (fire safety) volume 1: Dwellings, 2019 edition' and 'Approved Document B (fire safety) volume 2: Buildings other than dwellings, 2019 edition'. 16 April 2019 .

Get PriceEmail contact

Copyright © 2020.Company name All rights reserved.SiteMap